Volkswagen Automobiles Forum banner

Project Caddy/inca On A Very Tight Budget

4.9K views 5 replies 4 participants last post by  Autobahn  
#1 ·
This is how i got it this mornin ..... signage is already gone .... clean and buff it tomorrow

On a tight budget but things i want to do right away

Alloys ...size not sure at the minute
New seats .... recaro's or something simular
Caddy front bumper ....( as im sure you all can see its a Inca )
Steering wheel ..not sure what kinda yet
Complete respray

All comments and idea's more than welcome, a long time since i did something like this ....
Image
 

Attachments

#4 ·
yes it will, go to a breakers and get the bumper brackets and carefully measure were they sit on the wings and fit them to your inca. The inca wings will then have to be "technically modified" to take the caddy bumper I used a con saw but angle grinder will be fine. Then I think I modified the brackets under the front panel. The holes on the top side of the bumper lined up. Good luck with the porject get in contact if you need more info. I debated about removing side mouldings but I am glad i did.
 
#5 ·
yes it will, go to a breakers and get the bumper brackets and carefully measure were they sit on the wings and fit them to your inca. The inca wings will then have to be "technically modified" to take the caddy bumper I used a con saw but angle grinder will be fine. Then I think I modified the brackets under the front panel. The holes on the top side of the bumper lined up. Good luck with the porject get in contact if you need more info. I debated about removing side mouldings but I am glad i did.
 
#6 ·
Thanks for that bit of info... Had it my head to remove the side mouldings and soon as i saw you van , they where gone .. must get some pic's up of progress so far ...