Volkswagen Automobiles Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
546 Posts
Discussion Starter · #1 ·
I'm looking for somewhere in Ireland who can make up a 3" stainless steel cat back exhaust for the R32.

I've tried a few of the custom exhaust places, Souhans, Callaghans, and JON exhausts but none of them can bend anything over 2 1/2" pipe. I haven't found a 3" system off the shelf to suit so would have to go England to have one made.

Anyone any suggestions?
 

·
Registered
Joined
·
1,730 Posts
www.dairytube.ie sound lads, they're helping me with my 3.5" pipe.

304 stainless, check out the bend tables on their website. Their mandrel bends are top notch however the radii are a little bigger than you would like.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top